These are a WONDERFUL, Safe and Secure way to Transport your Blythe Dolls while traveling.
Note: Blue Car Seat Only. Dolls not included (I know, I am not sure why we have to add this for people to read either, but here it is).
Deron 3D Printed these Car Seats as Thrones just for Blythe. He made them first for my Bicycle so that I could take my Daisy Blythe with me on trips.
These are the same Seats I have been using on my Bicycle for my Daisy Blythe for well over 500 miles on Trails and Roadways, some very rocky and bumpy. We used Super Glue for the Attachment that clips into my Bicycle's Handlebars.
We will send along clips for the back of your Blythe's Seat that you can Super Glue (we have used it with SUCCESS) anywhere on the back of your seat, adjusting to your own Dash Board. We use a CB Microphone Clip, found on Amazon, or other place, that screws to your Dash Board for a secure fit.
Link to the type we use and the Seat Clips were made for. https://www.amazon.com/dp/B09NPHXV71/ref=sspa_dk_detail_1 or https://www.amazon.com/FANVERIM-Quality-Microphone-Holder-Two-Way/dp/B076HLP996
PLEASE NOTE!: We will not be held responsible for any damage you might incur to your vehicle or dolls. We are only giving suggestions of how you might use this product. You are responsible for your own vehicle and dolls.
From time to time you may need to replace the elastic on the seat, Blythe's Seat Belts. You can knot the elastic in the back, as I do on my Bicycle Seat for my Blythe, or you can sew the elastic together, FIRMLY!
Keep Shopping, you only pay Shipping once. All other items ship FREE!
This heavier item will ship for a higher flat rate of $4.95 to the USA. Lighter items can be included at no additional shipping costs. Your shopping cart will show your shipping costs and total based on the items in it.
This product is in-stock and ready for delivery.